The RockJock® III high pinion rearend assembly for the 2007 and up Toyota FJ Cruiser includes the complete housing with the 65-45-12 ductile iron housing center, AR400 heat treated bottom skid plate allowing the axle to slide over rocks easily, 3" d.o.m. steel tubes, 5/16" thick heavy steel diff cover, yoke (1310/1330/1350 optional). Unit features custom housing ends that accept the stock FJ axle bearings and allow for all factory disc brake hardware and ABS and ESP sensors to bolt back on. Housing also features new heavy duty Currie FJ suspension brackets mounted and urethane coil spring pads are included. Also included are the Currie performance forged alloy 35 spline axle shafts that feature the stock FJ 6 lug wheel bolt pattern and stock diameter register hub for proper rotor indexing. Axle kit features wheel studs installed, FJ axle bearings, bearing retainer rings, and oil seals. All you need to complete this unit is a high pinion Dana 60 ring and pinion gear set, Dana 60 35 spline carrier of your choice, center section bearing & set up kit, labor to set it up and your FJ's stock rotors, calipers, and caliper mounting brackets transferred over. Assembly labor of this unit is included in the price! Be advised: this unit does not accommodate the factory sway bar! See our universal Antirock® sway bar offerings. This unit is 66" wide.
NOTE: Sample image only, actual product may vary.