Shop by Brand


VIAIR Super Duty Onboard Air System


$799.95


By ordering a single part number, you can take all of the guess-work out of getting all of the parts you'll need to install one of the most sophisticated, all-inclusive onboard air systems available today. The Super Duty Onboard Air System comes complete with a two 325C, 33% Duty Cycle compressors at its heart that will fill the supplied 2.0 gallon tank from 110-150 PSI in approximately 24 seconds. Unlike our other systems, the Super Duty Onboard Air System includes a regulator and can run air tools. Included is everything you'll need to add a reliable air source to your vehicle as well as inflate tires with the included tire inflation gun. (For vehicles with up to 37-inch tires)

Includes:

    (1) 2.0 Gallon Viair Air Tank
    (2) 325C VIAIR Compressors
    (1) 30ft. Coil Hose
    (1) Tire Inflation Gun with 200 PSI Gauge
    (1) 0-150 PSI Pressure Regulator
    (1) Blow Gun
    (1) 1/4" NPT Quick Connect Coupler (F)
    (1) Dash Panel Gauge with ON/OFF Switch
    (1) Pressure Switch with Relay (110 PSI on, 150 PSI off)
    (2) 40-amp Relays
    (1) Inline Fuse Holder w/ Fuse
    (1) 1/4" NPT 175 PSI Safety Valve
    (1) 1/4" Drain Cock
    (2) 1/8" BSP to 1/4" NPT (Air Locker Use)
    (5) 1/4" NPT Compression Fittings
    (1) 4-inch Strip of Continuous Grommet Material
    (1) 20ft. 12 Gauge Wire with Inline Fuse Holder
    (2) T-Fitting (1/4"(M) x 1/4"(F) x 1/8"(F))
    (1) Electrical Connections

NOTE: We don't have vehicle specific installation diagrams. There are so many different compressors and so many different vehicles out there that it's best to check out the mounting diagrams online so that you can find a place to mount the compressor and air tank.

The compressor can be mounted in the cab, in the bed of the truck, under the bed or in the engine compartment.

  1. If mounting in the engine compartment, make sure it's not touching anything that would overheat it.
  2. If mounting in the bed or under the bed, try to position it somewhere clean and dry. Often times our customers will fabricate a mounting bracket or splash guard to protect the compressor from sucking in water and moisture. Be sure to use the remote air filter if the compressor is exposed to the elements.

  • Model: 10008
  • Manufactured by: VIAIR

Be the first to write a review.  Write a Review.



Manufacturer Discounts

Save 18% on all MBRP
MBRP

Manufacturer Info

Have you seen ...

Fourtreks

PayPal Credit

Your IP Address is: 18.97.14.85